Simple cut to length line

Material bearing and correction part of simple cut to length line

The material bearing and correction part of the simple cut to length line is also selected according to the customer's material. Like conventional stamping lines, it can be combined according to split equipment and two-in-one (GO, ML, CL, TGL, etc.). For the material-bearing part, select the model according to the material width and inner and outer diameters, select the pressing method according to the material thickness, and select the power and expansion method and whether to configure auxiliary supports according to the load-bearing. The correcting part selects the size and arrangement of the correcting wheels according to the thickness of the material, confirms the correcting motor power according to the speed, and determines the number, arrangement, and transmission mode of the correcting wheels according to the customer's requirements for flatness. As an export equipment, it is recommended that considering that foreign countries generally pay more attention to safety, it is recommended that the pressing arm of the material rack and the frequency conversion speed regulation of the correction should be considered as standard configurations in the quotation.

Feeding part of simple cut to length line

The feeding part of the simple cut to length line is completely differentiated and selected according to the customer's sizing requirements and efficiency of the plate. According to the difference of the power source, there are: AC frequency conversion sizing, DC motor sizing and servo motor sizing. For construction cross-cut shears whose material quality is not very good and the tolerance of the cut-to-length is relatively large, it can be cut to length directly by using a circuit composed of a correction power, a frequency converter and a length-measuring encoder. For materials with high thickness and strength, but low production capacity requirements, a circuit composed of a DC motor and a length measuring encoder can be used for sizing. For those with high speed requirements, high production capacity requirements and high automation requirements, choose servo sizing.

Cut part of simple cut to length line

The cutting part of the simple cut to length line is specifically divided into: the head shears that come with the equipment, the purchased finished mechanical (hydraulic) shears, the pneumatic clutch high-speed shears (or hydraulic high-speed shears), etc. For a simple cut to length line that requires little output, it can be cut directly with the head shears. For some relatively medium and low-grade cut to length lines with wide material width and large thickness range, purchased mechanical (hydraulic) shears can be used. For higher cutting requirements, if there is a certain speed requirement, choose pneumatic clutch high-speed shears (or hydraulic high-speed shears).

Simple cut to length line product collection method

The product collection method of simple cut to length line depends entirely on the nature of this type of production line required by customers. It can be divided into manual collection, simple lifting collection and automatic palletizing collection. For self-use equipment with thinner materials, shorter cut lengths and low output, manual collection and stacking can be used. For a fixed cut to length line with a long cut length (generally longer than 600mm, beyond the range of manual clamping), the width of the material does not change much, and a forklift can be used for fixed-length collection. For mass production with large variations in material width and length or the nature of the customer as a material supplier, automatic stacking is the first choice.

The simplified design of slitting and cut to length line used in the initial production of materials is developed and designed on the basis of retaining the basic functions of the corresponding production line. Especially for cross cutting, different matching can be produced according to different combinations, so as to meet the needs of different types of production. Like the stamping production line, it is necessary to make the best configuration plan based on the final needs of customers. So really understanding the real purchasing purpose of customers is the beginning of all work. Otherwise, if there is no inquiry for the detailed information of the customer, even if the technical department can make a plan, it is at best just a dowry of other people's plan. There is no success rate.

Cut To Length Lines Manufacturer - Bangzhou Machinery

BANGZHOU Machinery specializes in R&D and manufacture of cut to length lines. Our machines are used in a variety of industries, including the metal and aluminum sheet industry. We have a team of experienced engineers who are dedicated to create machines that are durable and easy to operate. We also have a team of customer service representatives who are available to answer any questions you may have about our products.